Park Scale Wisp Kits

The Park Scale Models Wisp Series features an innovative PowerPack Module that holds the motor and the AR6400 brick. Rare earth magnets are used to couple the brick servos to the control rods...allowing the Power Pack to be quickly moved to any airframe in the Wisp Series.


Park Scale Wisp Series Monocoupe 90a

The Monocoupe 90 was a light, fabric covered, two seat cabin aircraft built by Donald Luscombe in 1927. A total of 324 aircraft were produced frrom 1928 until the late 1940's.

The kit design comprises fully inter-locking parts making a full size plan unnecessary. Take a look at the assembly manual which is included with the kit.

Wingspan:19.125" (48.5cm)
Length:11.6" (29.5cm)
Wing Area:55in2 (345cm2)
Flying Weight:~1.7oz (48gm)

Recommended R/C:
Controls:Rudder, Elevator & Throttle
Receiver:AR6400 (or similar) or Parkzone Vapor module
Power System:Parkzone PKZ3624 with Parkzone PKZ3002 or PKZ3901 prop
Battery:100mAh - 160mAh 'UM' single Lipo cell

Required to complete:

  • Glues (CA and epoxy) plus building tools
  • Some small diameter heat shrink tubing
  • Covering material, e.g. Solarfilm So-Lite or tissue
  • Motor, battery and R/C gear as above

£ 28.80

Park Scale Wisp Series DHC-2 Beaver

The de Havilland Canada DHC-2 Beaver is a single-engined, high-wing, propeller-driven, STOL aircraft developed by de Havilland Canada. Primarily known as a bush plane, the Beaver has been used for cargo and passenger hauling, crop dusting and and has been widely adopted by armed forces around the world as a utility aircraft. A total of 1,657 aircraft were produced from 1947 to 1967.

The kit design comprises fully inter-locking parts making a full size plan unnecessary. Take a look at the assembly manual which is included with the kit.

Wingspan:20.5in (52cm)
Length:12.9in (32.7cm)
Wing Area:56.8in2 (366cm2)
Flying Weight:~1.4oz (40gm)

Recommended R/C:
Controls:Rudder, Elevator & Throttle
Receiver:AR6400 (or similar) or Parkzone Vapor module
Power System:Parkzone PKZ3624 with Parkzone PKZ3002 or PKZ3901 prop
Battery:100mAh - 160mAh 'UM' single Lipo cell

Required to complete:

  • Glues (CA and epoxy) plus building tools
  • Some small diameter heat shrink tubing
  • Covering material, e.g. Solarfilm So-Lite or tissue
  • Motor, battery and R/C gear as above

£ 28.80

© Micron Radio Control