Micron R/C is open on Mondays, Tuesdays and Fridays. For further details, see opening times.

Deltang Tx2 Pre-Wired Module

The pre-wired Tx2 allows the module to be installed in small enclosures without the pins getting in the way. The pins are de-soldered from a standard Tx2 and replaced with colour-coded wires:

Pin Colour
1white
2yellow
3blue
4green
5grey
6brown
7orange
8violet
3.1Vpink
negativeblack
positivered

To install:

  • snip any unused wires close to the heatshrink cover - TAKE CARE, verify twice before cutting
  • measure the required wire lengths by temporarily fitting the module in place and arrange the wires to each control; allow for the wire termination
    • build instruction that incorporate the wired module will have a table of recommended wire lengths
  • cut the wires to the correct length, strip 2mm from the end, twist and tin the wires
  • solder the wires into place, ensuring that the bundle of wires does not get twisted and protect any wire-to-wire joints with heatshrink tube - e.g. the positive lead-out wire to the battery connector wire

© Micron Radio Control